Interlocking 38/357 Speedloader Loader (K Frame 6rd, N Frame 8rd)

This is a remix of the interlocking loader-loaders by [masonEcooper](https://www.thingiverse.com/masonEcooper).
My initial version was similar to the masonEcooper design, with a "lollypop" shaped locking rib. All the rest are multiple wedge dovetail designs similar to the many other interlocking hexagon designs for various other things.

I found the dimensions here to be about perfect for printing with 0.2mm resolution on my PRUSA. They slide together snug, but the layer lines tend to "lock" them together sufficiently so they don't slide too readily. The wedge dovetails lock more solidly with less "wobble" between segments than the lollypops, and there's a notch in the wedges to put a locking pin into, if necessary. In any case, YMMV. Trimming or scaling might be needed for your printer. No supports are needed if your printer can handle 45 deg overhangs.

There's a little "K" or "N" printed on each part. If you point these letters in the same compass direction, the parts will fi