invelox

Inspired from this
https://www.windpowerengineering.com/sheerwinds-novel-invelox-wind-turbine-patent-portfolio-up-for-auction/

searching for a proper utilization, I found that it can be helpful for wind speed measuring, using a wind sensor. Additional sensors like temperature or humidity can be attached creating a weather station.

https://moderndevice.com/product/wind-sensor-rev-p/

http://moderndevice.com/product/sht21-humidity-and-temp-sensor/


The advantage to this solution is that it captures the wind no matter where the wind blows, because when beating it may change direction.

Wind catcher diameter is about 120 mm.
Long tube length 130 mm
Middle tube length 70 mm (for sensors purpose)
Short tube length 30 mm

Assembly instructions:

1. you will need to print 2 invelox_support.stl
2. inside of the previous parts it should enter the invelox_down.stl
3. on top of it, it should be placed the invelox_sensor_support.stl
4. in front of the inv