"Invisible" Tablet Wall Mount

“Invisible” Wall Mount for TabletsThis mount consists of two parts, which fit together with a sliding dovetail.One gets screwed to the wall with three screws.The other gets glued to the backside of the tablet. Tips for gluingMost glues will (temporarily) soften with heat.This heat could realistically occur through for example the sun or (fast) charging of the tablet. So make sure you are using the whole contact area for glue to minimize chances of the glue failing.I used some simple carpet tape and it has been holding great. But for a stronger mount I would probably recommend using 3M VHB double sided tape and waiting the recommended ~24hrs before putting any load on the glue (→ let it sit horizontally). Also it is sometimes recommended to compress the glue directly after applying it (use common sense, the 3d print and your tablet could suffer. Again i am not responsible, if you break your equipment or 3d print). Printing, Assembly & ToleranceFYI: Both parts on the same plate are sligh