Thingiverse
IOT Smart Drybox
by jmgk
6
Downloads
5
Likes
0
Makes
IOT Smart Drybox
====================
This is a wifi-enabled smart filament drybox.
Monitor humidity and temperature inside your drybox, and automatically turn heating on/off based in your parameters.
Accessible via mDNS, LLMNR, SSDP, NETBIOS and direct IP.
Firmware available at https://github.com/jmgk77/HTMON
Parts:
---------------------
* wemos d1 mini
* oled 0.96 ssd1306
* 1 channel relay shield
* sht30 temperature and humidity sensor
* HLK-PM01 (5V) mini power supply
* Oven Light Bulb (or another heater)
How to:
---------------------
Connect the wemos d1 mini to the oled display and the sht30 sensor via i2c. Run a wire from the wemos d1 mini to the relay, and connect the relay to the heater. Connect HLK-PM01 to the main power, and the 5v
====================
This is a wifi-enabled smart filament drybox.
Monitor humidity and temperature inside your drybox, and automatically turn heating on/off based in your parameters.
Accessible via mDNS, LLMNR, SSDP, NETBIOS and direct IP.
Firmware available at https://github.com/jmgk77/HTMON
Parts:
---------------------
* wemos d1 mini
* oled 0.96 ssd1306
* 1 channel relay shield
* sht30 temperature and humidity sensor
* HLK-PM01 (5V) mini power supply
* Oven Light Bulb (or another heater)
How to:
---------------------
Connect the wemos d1 mini to the oled display and the sht30 sensor via i2c. Run a wire from the wemos d1 mini to the relay, and connect the relay to the heater. Connect HLK-PM01 to the main power, and the 5v
jmgk also publishes on
6 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
