Thingiverse
Ip-Camera Wall Holder
von RenatoT
12
Downloads
12
Likes
0
Makes
Modeled in Cinema4D R23 with basic primitive managed with volume tools (voxels).
The main object is printed 0.2 mm layer, 3 shells, 25% infill. The screw is printed very well at 0.1mm layer size and concentric 100% infill. Just add 2 screws, 2 nuts and 4 washers.
I printed it without supports, just 2 bridge, but come out very well on Anycubic Vyper
The main object is printed 0.2 mm layer, 3 shells, 25% infill. The screw is printed very well at 0.1mm layer size and concentric 100% infill. Just add 2 screws, 2 nuts and 4 washers.
I printed it without supports, just 2 bridge, but come out very well on Anycubic Vyper
RenatoT veröffentlicht auch auf
4 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!