Thingiverse
IP2368 PD 100W bi-directional module panel mount
door blue_haniwa
0
Downloads
1
Likes
0
Makes
Panel mount for IP2368 100w bidirectional buck-boost module. I've created this with enough space to install heat-sink on bottom of the board.
Even with heat-sink, the module get very hot when I set it to 60w so for higher wattage active cooling is needed.
The design was a bit tricky because the board didn't have any mount point or screw holes, but this worked for me.
There are 4 models included:
- Bottom cradle
- Top cradle
- Outer panel for presentation
- Cutout template to help draw lines on the panel you need to cut
To install the board on the cradle you'll need 2 zip-ties, and for mounting to your panel you'll need 2 M3x8 or longer machine screw with 2 M3 nuts.
Even with heat-sink, the module get very hot when I set it to 60w so for higher wattage active cooling is needed.
The design was a bit tricky because the board didn't have any mount point or screw holes, but this worked for me.
There are 4 models included:
- Bottom cradle
- Top cradle
- Outer panel for presentation
- Cutout template to help draw lines on the panel you need to cut
To install the board on the cradle you'll need 2 zip-ties, and for mounting to your panel you'll need 2 M3x8 or longer machine screw with 2 M3 nuts.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
