Thingiverse
iPad Air 3. Gen Wall Mount
von chico11
4
Downloads
0
Likes
0
Makes
iPad Air 3rd Generation Wall mount.
The holes for the screws have a diameter of 2,5mm for screws.
There are two recesses where magnets can be inserted and glued. However, it also works very well without magnets.
IMPORTANT NOTICE: Please make sure that you use retractable screws and screw them so far into the holes that they are deeply countersunk and do not stick out at the top! Otherwise you will scratch the back of your iPad when pushing it in!
Mirror the STL in Slicer to get the other part.
The holes for the screws have a diameter of 2,5mm for screws.
There are two recesses where magnets can be inserted and glued. However, it also works very well without magnets.
IMPORTANT NOTICE: Please make sure that you use retractable screws and screw them so far into the holes that they are deeply countersunk and do not stick out at the top! Otherwise you will scratch the back of your iPad when pushing it in!
Mirror the STL in Slicer to get the other part.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
