Thingiverse
Ipad holder
by Roffe1440
33
Downloads
17
Likes
0
Makes
This is an Ipad/tablet holder made for my Ipad Pro and Iphone. Its easy to use and works ok.
I made it since I am an archery coach and I use different types of software om ny iPad/Iphone and I wanted a holder that worked for both devices. I have two types of bullheads on my tripods. One is Arca Swiss and the other one is Manfrotto. So I made two holders. I have used it for some time and it works well.
However. You are using the holder on your own risc. I will not replace any broken iPads/tablets/phones/iphones. Make sure that you have secured the tablet/phone properly, you don't have over tighten the screws. If you have any problems please contact me so I can improve the design.
You have to print one of the holder files. It includes bottom and top.
You need two Screws, ie nut holders.
You need the following
2 pieces M5 nut.
1 threaded rod M5. Length approx. 36 cm or 14 inches.
You can make it shorter if you like. Just make sure its easy to take out your device.
I made it since I am an archery coach and I use different types of software om ny iPad/Iphone and I wanted a holder that worked for both devices. I have two types of bullheads on my tripods. One is Arca Swiss and the other one is Manfrotto. So I made two holders. I have used it for some time and it works well.
However. You are using the holder on your own risc. I will not replace any broken iPads/tablets/phones/iphones. Make sure that you have secured the tablet/phone properly, you don't have over tighten the screws. If you have any problems please contact me so I can improve the design.
You have to print one of the holder files. It includes bottom and top.
You need two Screws, ie nut holders.
You need the following
2 pieces M5 nut.
1 threaded rod M5. Length approx. 36 cm or 14 inches.
You can make it shorter if you like. Just make sure its easy to take out your device.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
