iPad Pro Tripod Mount

I liked the design by DIY3DTech but I wanted this to hug my tablet a little tighter. I adjusted the slot size and the bolt hex head hole on the bottom. I made this one a little wider as well to add more stability for the iPad. The bolt head hole was made so that it would be easily printable without any supports. I also added a slot for an additional pin that's on my tripod mount.

Other hardware I used:
- 1 1/4"x8" hex head bolt
- 1 1/4" nut
- 1 1/4" flat washer
- 1 1/4" wing nut