Thingiverse
Ipad stand for thicker cases
von MASS3D
13
Downloads
6
Likes
0
Makes
I did this one because my daughter´s ipad stand broke. It has a thick rubber enclosure so i couldn´t find any that fits.
It takes hour and a half to print and i tried to make it use the less filament posible.
It takes hour and a half to print and i tried to make it use the less filament posible.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
