Thingiverse
iPad Support and Adjustable Stand
di MauiMacMan
10
Download
4
Likes
0
Makes
I will need to get revised photos up of the new layout! I made this from scratch for my Mom's iPad 2. Its five pieces that press fit together. The H support member, is printed in two halves that have to be glued together then placed in the upper hole of the S curve's. The base could be refined.
I revised the base and the H member so once constructed, you can flatten the contraption. Next, The long rod should be threaded through the base holes and bottom holes of the support S curves. You can heat the ends of the rod for flattening the ends so it doesn't come apart...or leave it loose for deconstruction and portability.
I know its, big, and not very expedient (5 hr print approx) but for Mom with clumsy fingers, it works great. I coated the bottom of the base with liquid rubber (Dipit) so it grips the surface of the table for safer and better iPad, iPhone support.
I revised the base and the H member so once constructed, you can flatten the contraption. Next, The long rod should be threaded through the base holes and bottom holes of the support S curves. You can heat the ends of the rod for flattening the ends so it doesn't come apart...or leave it loose for deconstruction and portability.
I know its, big, and not very expedient (5 hr print approx) but for Mom with clumsy fingers, it works great. I coated the bottom of the base with liquid rubber (Dipit) so it grips the surface of the table for safer and better iPad, iPhone support.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
