Thingiverse
iPad Tripod Mount
von moose408
16
Downloads
17
Likes
0
Makes
I needed to attach my iPad Air 2 to a tripod. I found a lot of examples but they all assumed there was no case on the iPad. I didn't want to remove my case every time so I just designed my own.
This will fit an iPad Air 2 with a full smart case. The maximum thickness is 11.5mm.
The tripod mounting plate attaches with a 1/4-20 screw and hex nut.
I printed this with supports and used PETG because I plan to keep this in my car and didn't want it to warp.
This will fit an iPad Air 2 with a full smart case. The maximum thickness is 11.5mm.
The tripod mounting plate attaches with a 1/4-20 screw and hex nut.
I printed this with supports and used PETG because I plan to keep this in my car and didn't want it to warp.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
