Thingiverse
iPad Wall Holder Bat
door m-heim
0
Downloads
0
Likes
0
Makes
An iPad holder i made for our kitchen. For use with 3/3.5 mm countersunk screws
My iPad has a case so it might be loose or doesnt fit, depending on the dimensions of your tablet. On request i might add other thicknesses
Measurements used for slot: 285 x 195 x 19.4 mm
It is recommended to print the 2 parts flat, this way only the corners need supports (which will go through the bats)
Licence: CC BY-NC
My iPad has a case so it might be loose or doesnt fit, depending on the dimensions of your tablet. On request i might add other thicknesses
Measurements used for slot: 285 x 195 x 19.4 mm
It is recommended to print the 2 parts flat, this way only the corners need supports (which will go through the bats)
Licence: CC BY-NC
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
