MakerWorld
Electronics
Go to Model
iPhone 16 Pro Max Screen Protector Alignment Jig
222
Downloads
45
Likes
131
Makes
I made this jig to help align glass screen protectors on the iPhone 16 Pro Max. It's designed to make a snap fit on the frame to keep it in place while you're laying down the screen protector. I designed it around a screen protector that is approximately 159mm tall and 73mm wide. On my X1C running normal mode and PLA+ it only uses 6 grams of filament and prints in under 20 mins. No supports or brims needed.Boost MeBoosts are greatly appreciated!
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
