Thingiverse
iPhone 4 Tripod Manfrotto Quick Release
door 3DTOPO
7
Downloads
13
Likes
0
Makes
I made the angled bevels match the same angle as my tripod head, I made it considerably thinner for faster/cheaper prints. Resized to fit perfectly in my Manfrotto 700RC2 fluid head.
I was at first a bit skeptical of this design; I was concerned that the iPhone could slip out, but it is able to firmly grasp the iPhone even upside-down (see photo).
I was at first a bit skeptical of this design; I was concerned that the iPhone could slip out, but it is able to firmly grasp the iPhone even upside-down (see photo).
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!