Thingiverse
iPhone 6 Dock MSI Style
by stunner2211
25
Downloads
33
Likes
0
Makes
This is yet another iPhone Dock in MSI Style. I used red 6mm LEDs to light it up. Unfortunally i dont have a Picture of the Installation but i upload one foto from AutoCAD to explain the Installation.
First, i removed the Isolation of the cable and measured out, which cables are powered. Then i soldering an extra cable on it and glue the conector in place. After all is dried, i soldering two 50Ohm resistors (one resistor for 2 LEDs in one Line) and all LEDs together. (See attached wiring diagramm).
At least i glue the bottom piece on the main part and its done :). Optional i put two 3mm holes in the bottom to screw the bottom piece.
First, i removed the Isolation of the cable and measured out, which cables are powered. Then i soldering an extra cable on it and glue the conector in place. After all is dried, i soldering two 50Ohm resistors (one resistor for 2 LEDs in one Line) and all LEDs together. (See attached wiring diagramm).
At least i glue the bottom piece on the main part and its done :). Optional i put two 3mm holes in the bottom to screw the bottom piece.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
