Thingiverse
iPhone 6 Mount for Tripod
von makerbotman
8
Downloads
3
Likes
0
Makes
Printed 0.2mm layer height, 35% infill, 2 shells, 0.8mm floor & roof, support for the holes (Meshmixer), printed using Proto Pasta HTPLA, white.
Insert 3 x TriStar Inserts (H2520 x 364P), little bit of soldering iron, little bit of push. (May be hard to find these inserts, sorry).
Slides snugly onto iPhone Six with generic-ish case. Best to slide from bottom up to avoid buttons.
Insert 3 x TriStar Inserts (H2520 x 364P), little bit of soldering iron, little bit of push. (May be hard to find these inserts, sorry).
Slides snugly onto iPhone Six with generic-ish case. Best to slide from bottom up to avoid buttons.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!