Thingiverse
iPhone 6 Plus Case
von jim_sab
42
Downloads
41
Likes
0
Makes
This case prints as one piece and protects all corners of the phone, difficult to manage with a one piece hard plastic case.
To put on the case simply slide the top half of the phone in and snap on the bottom segment.
The ribs on the bottom of the phone act as not only protective barriers for the phone in case of drops, but as great finger holds for added protection.
To put on the case simply slide the top half of the phone in and snap on the bottom segment.
The ribs on the bottom of the phone act as not only protective barriers for the phone in case of drops, but as great finger holds for added protection.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
