iPhone11 case fast easy print

UPDATE, it's a little tight, may want to scale it up a couple percent. It does fit though. if you have good results, please share your make. I was able to print it in about 3-1/2 hours @ 30mm/s 100% infill. I only needed access to the silence switch, so I crudely punched a hole in after it was printed. All other buttons work great through the wall of the print. I wirelessly charge, so I didn't cut out the charge port.

This is a quick easy print without cutouts so there is no need for supports. If you wirelessly charge, you don't even need to cut out the port for the plug. The areas over the buttons should be thin enough you can press the button through the case, you will need to punch a single hole where the switch is for silent mode if you so desire. I wanted a super easy print in the few hours I have before I go camping so I don't damage my new phone before the case arrives in a couple days.