Thingiverse
iPhone6 Car Mount
door DanLuc
16
Downloads
12
Likes
1
Makes
Its the same holder as the VW one I made before bu the back is made for that "T" part in the fan grill. Its also slightly tilted towards the driver for um GPS use?
Its got a small cutout at the bottom so i can turn on and off my 4 way blinkers as well. At the back its got nice rounded baffles to redirect the air around the unit, especially the hot air during winter. It works well with thin profile cases so you wont have to remove the phone case while using this holder.
I printed it standing to prevent warping. The double sided tape i got from Home Depot and its that 3M red tape that's a bit rubbery.
Its got a small cutout at the bottom so i can turn on and off my 4 way blinkers as well. At the back its got nice rounded baffles to redirect the air around the unit, especially the hot air during winter. It works well with thin profile cases so you wont have to remove the phone case while using this holder.
I printed it standing to prevent warping. The double sided tape i got from Home Depot and its that 3M red tape that's a bit rubbery.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
