iPod Classic 7th gen case (not thick case models)

A simple case for the 7th generation iPod classic… I designed this for the 160gb model I have (Model no. MC293 in the about screen) but should fit any of the slim 6th gen models too (I believe 6th gen 80gb and 120gb are slim but early 160gb 6th gen have a thicker case back)…I used some fairly generic/cheap TPU to print this (Eryone TPU from Amazon)… slowed everything down to around 60mm/s to get decent results… I have also tried Bambu Labs TPU for AMS but this results is a case that “flexes” enough to get the iPod in but not enough give to get it back out again despite have the infill low and holes in the side of the case so I WOULD NOT recommend using this for the print… Not tried the new Bambu TPU 90A as yet but will upload a separate profile when I get some to try and assuming the results are ok The profile has the plate specifically set to be textured as I felt this gives a nice finish and helps with adhesion but forgot to use a glue stick on the plate first to help with the releas