Thingiverse
iPod L-Shaped dock case
by lo1ol
0
Downloads
3
Likes
0
Makes
It's really hard to find L-shaped iPod dock cable in nowadays. So, I decided to create L-shaped dock case for dock from Aliexpress.
You need to
1. buy large dock (see photo) from Aliexpress
2. Disassemble it
3. Cut most part of it
4. Solder wires to pins (see photo). Bottom (GND) of jack -> second pin. Middle (Right) -> fourth pin. Top (Left) -> third pin. Not forget to pass wire through printed case firstly:)
5. Install top part of adapter in printed case. You also can print this part:)
I supplied Fusion 360 file. So, you can edit model for your needs.
You need to
1. buy large dock (see photo) from Aliexpress
2. Disassemble it
3. Cut most part of it
4. Solder wires to pins (see photo). Bottom (GND) of jack -> second pin. Middle (Right) -> fourth pin. Top (Left) -> third pin. Not forget to pass wire through printed case firstly:)
5. Install top part of adapter in printed case. You also can print this part:)
I supplied Fusion 360 file. So, you can edit model for your needs.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
