Thingiverse
IRF520 8x Support
door condruttoma
0
Downloads
2
Likes
0
Makes
I needed a stand to accommodate the 8 IRF modules in a compact form factor so I came up with this one.
It has a slot for a 2.1mm female power plug between the two towers.
You want to print it face down, this way, almost no support is needed.
It isn't the ideal design, as you have no access to the screwterminals once inserted,
but it was a tradeoff I was willing to make to achieve a clean look.
When inserting the module, you want to push one clamp with the module while pulling on the other one, in order to avoid one arm breaking off due to overextension.
Also, if I there is something I can design for you, you can always drop me a line on fiverr:
https://www.fiverr.com/share/pdgm9N
It has a slot for a 2.1mm female power plug between the two towers.
You want to print it face down, this way, almost no support is needed.
It isn't the ideal design, as you have no access to the screwterminals once inserted,
but it was a tradeoff I was willing to make to achieve a clean look.
When inserting the module, you want to push one clamp with the module while pulling on the other one, in order to avoid one arm breaking off due to overextension.
Also, if I there is something I can design for you, you can always drop me a line on fiverr:
https://www.fiverr.com/share/pdgm9N
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
