Thingiverse
Irig Mount
von SEXT9
5
Downloads
3
Likes
0
Makes
This is used to mount an iRig HD to a 1" rod.
In my case the 1" rod was a microphone stand.
You'll need to make 2 copies, one for each end.
A rubber band over the prongs keeps it in place.
In my case the 1" rod was a microphone stand.
You'll need to make 2 copies, one for each end.
A rubber band over the prongs keeps it in place.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
