Thingiverse
Gadgets
Go to Model
Iris Door Box v4
218
Downloads
139
Likes
5
Makes
This is a rework of Countspatula's Iris Door Box.
It's designed in FreeCAD and completely parameterised.
There's a small manual within the FreeCAD file with some explanations about the parameters.
Some of the design aspects have been changed:
- The functionality of the ring and the base are swapped.
- The leaves are made out of 2 parts, a top and a bottom, that are positioned at an offset so they support each other.
- The cut-outs in the leaves lock them in open and closed position.
The screws in the picture are covered with the screw caps I posted before.
It's designed in FreeCAD and completely parameterised.
There's a small manual within the FreeCAD file with some explanations about the parameters.
Some of the design aspects have been changed:
- The functionality of the ring and the base are swapped.
- The leaves are made out of 2 parts, a top and a bottom, that are positioned at an offset so they support each other.
- The cut-outs in the leaves lock them in open and closed position.
The screws in the picture are covered with the screw caps I posted before.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
