Irisbox with raisable bottom

A small little container with an iris mechanism as the opening. In addition, the bottom of the box is also rotatable, allowing the floor of the internal compartment to be raised and lowered for easier access. If this mechanism is not desired, I also provided a box without. This leaves more room for storage. Both versions require the following pieces:Box5 bladesGripturn operatortopThe complete version also requires:2 lower turners2 jointscentral coilraiserThe assembly of the upper part is relatively straight-forward. The lower section of the complete version has to be assembled by sliding both lower turner onto the box and locking them with the 2 joints. Afterwards, the central coil has to be inserted into its slot and the raiser put in place. Here, a bit of rotation allows for easier insertion. Printed with 0.12 mm layer height for aesthetic reasons. This also allows supports to be omitted in the printing process. Update 29.11.24Due to some remarks regarding the assembly, here a little