Thingiverse
Irken Labs JAMMA Expander Case
door Zepherino
2
Downloads
1
Likes
0
Makes
Case designed for the Irken Labs JAMMA Expander. It's oversized to accommodate the included HDMI and power cable, but should be easy to modify/shorten if needed.
Four M3x16 bolts, and 8 M3 heat threaded inserts (3.85mm OAL, 5.12mm diameter) are needed for installation. The ones I used were from initeq (random eBay purchase), but others should work fine if the dimensions are the same. The JAMMA Expander also has four M3 bolts preinstalled on the board that will be reused.
Don't use wood fill PLA like the picture shows. That was a done on a whim by me, and was a bad idea for a variety of reasons.
Four M3x16 bolts, and 8 M3 heat threaded inserts (3.85mm OAL, 5.12mm diameter) are needed for installation. The ones I used were from initeq (random eBay purchase), but others should work fine if the dimensions are the same. The JAMMA Expander also has four M3 bolts preinstalled on the board that will be reused.
Don't use wood fill PLA like the picture shows. That was a done on a whim by me, and was a bad idea for a variety of reasons.
Zepherino publiceert ook op
8 extra modellen op 1 andere platforms
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
