Thingiverse
Iron man boot jets
by Pyro_designs
0
Downloads
0
Likes
0
Makes
These are the stl files for an iron man boot jet. the hinges connect to the backplate so it can flip backwards. You may have to rescale the dimensions to fit your legs/feet. You can put the screw holders anywhere you want, but you will need them to hold the back and the front of the boot together. The boot should be printed in PA6-CF filament, at about a 25-30% infill. There are indents in the boot for where the rocket motors are supposed to go. If you would like to build the flying part of the boot jets: here are the instructions below(You may have to adjust it based on your weight): Rocket-Powered Boots Design
Objective: Lift a 150 lb person with a 2:1 thrust-to-weight ratio (TWR) using 4 rocket motors per boot (8 total).
1. System Specifications
User Weight: 150 lbs (68 kg)
Desired TWR: 2:1 → Total Thrust Required = 2 × (User Weight + System Weight)
Estimated System Weight (Boots + Rockets + Frame): ~50 lbs (22.7 kg)
Total Weight to Lift: 200 lbs (90.7 kg)
Total Thrust Needed:
Objective: Lift a 150 lb person with a 2:1 thrust-to-weight ratio (TWR) using 4 rocket motors per boot (8 total).
1. System Specifications
User Weight: 150 lbs (68 kg)
Desired TWR: 2:1 → Total Thrust Required = 2 × (User Weight + System Weight)
Estimated System Weight (Boots + Rockets + Frame): ~50 lbs (22.7 kg)
Total Weight to Lift: 200 lbs (90.7 kg)
Total Thrust Needed:
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!