Thingiverse
IRWIN Mobile Command Center Latch
von lboucher
0
Downloads
0
Likes
0
Makes
Hi All
This is a latch for the Irwin Mobile Command Center. Made this for my dad out of ABS.
The one little nub thing is bad geometry for printing with the layer orientation, so i slather it with ABS glue when done for strength.
This was printed on its side with supports.
https://www.lowes.com/pd/IRWIN-Mobile-Command-Center-40-5-in-Gray-Structural-Foam-Lockable-Wheeled-Tool-Box/1000306701
This is a latch for the Irwin Mobile Command Center. Made this for my dad out of ABS.
The one little nub thing is bad geometry for printing with the layer orientation, so i slather it with ABS glue when done for strength.
This was printed on its side with supports.
https://www.lowes.com/pd/IRWIN-Mobile-Command-Center-40-5-in-Gray-Structural-Foam-Lockable-Wheeled-Tool-Box/1000306701
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
