Thingiverse
IRWIN Quick-Grip Clamp Stand
por Department_Nine
831
Descargas
1.3k
Likes
4
Makes
Handy for those times you wished you had a third hand: use as anything from an oversized solder stand, to holding things while they dry, or when you Dremel the daylights out of something, etc.
- Stand-alone or clamp the stand to keep it secure, in the centre or using the tabs.
- Use the bracket on top for a secure and permanent connection.
- The walls of the holes in the base add compression strength.
- The flanged screw adapter can be used to mount the bracket to a bench with an M6 (1/4") bolt (h/t ziz62266).
- There are two versions:
-- One using four M3x12 (or longer) screws, washer and nuts, because everyone has some of those kicking around, and
-- The other using four M4x25 (or a bit longer) cap screws, washers and nuts (assemble upside down so your nuts don't fall out). Although the M3 version is plenty strong, this one is stronger.
Check out more designs from
Department_Nine.
- Stand-alone or clamp the stand to keep it secure, in the centre or using the tabs.
- Use the bracket on top for a secure and permanent connection.
- The walls of the holes in the base add compression strength.
- The flanged screw adapter can be used to mount the bracket to a bench with an M6 (1/4") bolt (h/t ziz62266).
- There are two versions:
-- One using four M3x12 (or longer) screws, washer and nuts, because everyone has some of those kicking around, and
-- The other using four M4x25 (or a bit longer) cap screws, washers and nuts (assemble upside down so your nuts don't fall out). Although the M3 version is plenty strong, this one is stronger.
Check out more designs from
Department_Nine.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!