ISI creamer cap

Hi there,

this part here is a replacement part for a creamer of branch 'ISI'. the original thread (it is something like M7x1 ) is gone , so I decided to construct this one very close to the original one. It is not exactly the same part.

I printed it in ABS,0.1 mm, just in case i'll put it in the dish washer. I think you'll need to improve the surface with some acetone, otherwise the cream will stick to that horrible printing surface and you'll get some diseases, the jack or something else…

it fits perfect after You tightened once that thread with a tool.

in that moment I'm experimenting on hot ends, so my prints don't look that good, as you can see it in the pictures. (don't know why I actually need to reduce all my temperatures by 20 °C)

hope you like it