Thingiverse
ITX Open Frame Quick Print Stand - Open Case
por morganlowe
11
Descargas
21
Likes
0
Makes
I had a pile of parts and no case, so I whipped this up. Printed in 5.5 hours with PLA 0.4mm nozzle and 50mm/sec on the slow machine.
Has holes for M3 screws. I used plastite screws but even PC case screws fit.
The little stand on the back is for a 10MM pushbutton switch for power.
The pictured machine is an older Intel ITX board with a Radeon RX590. It's plenty strong to hang off the GPU.
Has holes for M3 screws. I used plastite screws but even PC case screws fit.
The little stand on the back is for a 10MM pushbutton switch for power.
The pictured machine is an older Intel ITX board with a Radeon RX590. It's plenty strong to hang off the GPU.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
