Thingiverse
Ivar FlashLight Holder 2
von ctheroux
25
Downloads
15
Likes
1
Makes
This is a flashlight holder who is installed on the side unit of the Ivar
shelving system. The hole holding the flashlight is 4.5 cm in diameter. It
fits flashlight that uses D-cell batteries. You will also need 2 #4-40, 3/8"
bolts and the matching nuts. Support material is not needed. An infill of 40%
is recommended.
This object main web page is:
http://www.ctheroux.com/ivar-flashlight-holder-2/.
You can request the source files on the page listed above.
shelving system. The hole holding the flashlight is 4.5 cm in diameter. It
fits flashlight that uses D-cell batteries. You will also need 2 #4-40, 3/8"
bolts and the matching nuts. Support material is not needed. An infill of 40%
is recommended.
This object main web page is:
http://www.ctheroux.com/ivar-flashlight-holder-2/.
You can request the source files on the page listed above.
ctheroux veröffentlicht auch auf
406 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
