Thingiverse
J Head fan duct
von peke
84
Downloads
53
Likes
2
Makes
**************** UPDATED *************************
Thickness in the lower part reworkd, printed OK .
*******************************************************
I tried to creates something light to cool down the cold part of the head.Walls are 1mm thick.
The square holes are designed to secure the installation with a small zip tie.
This new version should clip by itself on the head if not, a short time under an air dryer should help.
Compared to the photo shown, the duct has been rezised ( 10 mm longer ) to allow the clipping on the head and the lower duct cool down of the melted filament .
Not printed yet, feedback are welcome !!!
Solidworks file attached for further mods . Help yourself ;-)
Thickness in the lower part reworkd, printed OK .
*******************************************************
I tried to creates something light to cool down the cold part of the head.Walls are 1mm thick.
The square holes are designed to secure the installation with a small zip tie.
This new version should clip by itself on the head if not, a short time under an air dryer should help.
Compared to the photo shown, the duct has been rezised ( 10 mm longer ) to allow the clipping on the head and the lower duct cool down of the melted filament .
Not printed yet, feedback are welcome !!!
Solidworks file attached for further mods . Help yourself ;-)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!