Jack-o'-lantern decoration

This is a Jack-o'-lantern decoration I created to hang from our driveway gate. I'm sure it has other uses, so I am uploading it here. It contains a pause to allow for the color change. The gate clips and snap clips are in a separate model file. The gate clips are designed to fit a horizontal pipe with a diameter around 42.8mm. The Jack-o'-lantern contains two holes on the top for the snap clips. If you can't use the gate clips, you should be able to print the two snap clips, insert them into the Jack-o'-lantern, and tie something between them to hang it up. It is probably thick enough to stand on a shelf or other stable surface. I added extra top and bottom layers so the sun would not shine through and show the infill while hanging from the gate. If you are not putting this outside, where the sun will shine behind it, you can probably lower those back down.