Thingiverse
Jackalope Key Holder
von clsinwv
107
Downloads
122
Likes
0
Makes
This is a large jackalope key holder. there is a hole in the mouth to pause the print and place a magnet. Use caution when adding the magnet. I glued it so it wouldn't stick to the extruder. I printed the bottom 3 cm, the back 4 cm, and the antlers in 100% infill. This is to keep the antlers from snapping and keep the jackalope from toppling. It absolutely needs supports.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
