Thingiverse
JÄRVFJÄLLET Headrest Extender
by Balthassar
1
Downloads
0
Likes
0
Makes
A headrest extension for the IKEA JÄRVFJÄLLET chair.
Fair warning, the bottom is so tight I had to dip it in boiling water to get it to fit.
I printed mine at 100% infill, for the durability and rigidity, and without supports; the undersides of the overhangs of the fancy top bit didn't look great, but those bits aren't visible when assembled, and the visible top surface was unaffected.
Fair warning, the bottom is so tight I had to dip it in boiling water to get it to fit.
I printed mine at 100% infill, for the durability and rigidity, and without supports; the undersides of the overhangs of the fancy top bit didn't look great, but those bits aren't visible when assembled, and the visible top surface was unaffected.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
