Thingiverse
Jansen's linkage
von JanArjen
5
Downloads
4
Likes
1
Makes
This is my take on the strandbeest.
The design is only for a single leg, I wanted to know how it worked.
Looking up animations on internet is just not the same as having a working demonstrator.
The dimensions of the strandbeest leg are copied from wikipedia:
https://en.wikipedia.org/wiki/Jansen%27s_linkage
The 3d design is minimal, allowing fast printing.
Use 3mm bolts to attach each segment (as seen on photo)
The design is only for a single leg, I wanted to know how it worked.
Looking up animations on internet is just not the same as having a working demonstrator.
The dimensions of the strandbeest leg are copied from wikipedia:
https://en.wikipedia.org/wiki/Jansen%27s_linkage
The 3d design is minimal, allowing fast printing.
Use 3mm bolts to attach each segment (as seen on photo)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!