Thingiverse
Jar Lid
by JSpeed
88
Downloads
70
Likes
0
Makes
Update: Sept. 17, 2017
Uploaded 89mm and 90mm lids, version 2. Again, no version 1.
80mm Lid didn't fit any jars I had (D'OH) 89mm was a tiny bit to small for 1 jar, but the 90 fits my 1 gallon jar.
Update: Aug. 24th, 2017
Uploaded version 2. This version has a recess in the lid to accept the mouth of the jar. Simple change.
Also uploaded an 80mm lid, version 2. Did not make a version 1 of this lid. So far, I've not printed it.
I'm using an empty pickle jar to store a little water and the lid started rusting. Searched the Thingiverse and could not find a replacement. Created this one. It's a 72mm jar lid for a 1/2 gallon pickle jar.
Used a tiny amount of liquid rubber for a gasket.
More sized will be added as I create them.
Uploaded 89mm and 90mm lids, version 2. Again, no version 1.
80mm Lid didn't fit any jars I had (D'OH) 89mm was a tiny bit to small for 1 jar, but the 90 fits my 1 gallon jar.
Update: Aug. 24th, 2017
Uploaded version 2. This version has a recess in the lid to accept the mouth of the jar. Simple change.
Also uploaded an 80mm lid, version 2. Did not make a version 1 of this lid. So far, I've not printed it.
I'm using an empty pickle jar to store a little water and the lid started rusting. Searched the Thingiverse and could not find a replacement. Created this one. It's a 72mm jar lid for a 1/2 gallon pickle jar.
Used a tiny amount of liquid rubber for a gasket.
More sized will be added as I create them.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
