Järda Lamp

THIS LAMP ONLY LOOKS GOOD WITH TRANSLUCENT FILAMENT, THE SHADE IS TOO THICK FOR NON TRANSLUCENT FILAMENTS It has a nice blue glow and yellowish glow under the shade where it isnt filled. The photos are with a 3000K white strip. If you have white translucent filament it could be real fun with RGB strips but this is enough Otherwise pretty clear how to work with this, The wire goes through the guide in the lamp body, to the strip through the holes, and the strip is stuck around the cylinder. the top is optional, but if you dont want to see the strip i strongly recommend installing it. The body is attached to the lamp via a screw, i added some clearances but this wont work with too rough settings or bad printer. The rest is glued. You glue the shade onto the interface and the cap onto the shade, The rest is kidna obvious.¨ Keep in mind to leave fuzzy skin on, to add the *sparkle* to the shade, also diffuses the light really good. Any strip will do, i purchased mine for 240 CZK or 8-9 EUR.