Thingiverse
JBL Control One Stand
von onecton
8
Downloads
7
Likes
0
Makes
I was fed up with Speaker stands not really conforming to the underside of a JBl Control One. So i made a stand myself.
It doesn't interfere with the speaker Grille, so you can take it on and off with ease. The contour of the stand follows the roughly 40mm radius of the boxes outside.
The Stand angles the box at 10°, for easier printing on smaller printers, the back is open so you can print two at the same time.
It doesn't interfere with the speaker Grille, so you can take it on and off with ease. The contour of the stand follows the roughly 40mm radius of the boxes outside.
The Stand angles the box at 10°, for easier printing on smaller printers, the back is open so you can print two at the same time.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
