JBL Flip 7 Bluetooth Speaker holder

I recently purchased a JBL Flip 7 to replace my older speaker and I needed a magnetic mount to place in a very specific spot at work. So I jumped into Fusion 360 and began to model the holder. This uses magnets and I've included models with 0, 4, 5 and 7 magnets, depending on how strong you want them to hold on. Where I am using the speaker is high in the air, so I want to absolute most grab possible, so I use these super strong magnets and I printed mine with 7 of them . Magnets Used (same as in my fidget slider design) https://amzn.to/3EWvHaR There are 5 models to choose from Very Tight Fit - 7 Magnets Easier to Assemble - 0 Magnets Easier to Assemble - 4 Magnets Easier to Assemble - 5 Magnets My Favorite - Easier to Assemble - 7 Magnets The "Very Tight" Version uses backward geometry to basically lock the round brackets that hold the speaker to the base and make it very hard to pull apart - use this model if you plan on leaving the entire setup together and charge the speaker in the