JCD 858D Nozzle Holder

I just got a JCD 858D station and was somewhat disappointed that there was no nozzle storage. I quickly designed this to hold the 3 included nozzles on the top, and it's held in place with an already existing screw. This screw holds on the front panel, so when undoing it, the front will want to slide out. Make sure you have it unplugged when doing this. I printed mine out of ABS, but anything should work just fine, so long as the nozzles aren't hot when placing them in the holder. Simply tightening down the screw holds it in place, however the mound slides/swivels on you, you could add a piece of double sided tape to the bottom, or a small amount of glue. If downloading the STL and using your own slicer settings, nothing particularly special is needed. There are multiple flavors of the 858D both from JCD as well as others. If yours does not match the one in the pictures, it may or may not work… If the screw is there in the top center, it likely will. Luckily it's a short pr