Jeep Duck Tray

A ducky holder for my brother's Jeep, complete with a slot to hold his phone. The tray fits snugly in the storage compartment on the dash.

I printed it with PETG to give it some resistance to heat from the sun. I would not advise using PLA.

Note: The STL file is saved in Inches. If your slicer doesn't convert it properly, you will have to manually scale it up by 2540% to convert it to millimeter standard.

This will fit on a 235mm x 235mm printer bed if you rotate it 45 degrees. I successfully printed it on my Ender 3.