Jeep Ducks - WizardDuck

My wife recently got a Jeep Willis, and now she's on the Ducks in the Jeep train…So I thought I would make a few custom ducks for here. Here is another one. The Wizard duck.‘You… shall… not…. QUACK!’ I would suggest something a bit more heat resistant than PLA, as these guys sitting on the dash may bake a bit and melt. I print with Bambu PETG-HF. On the yellow plate, there are 2 ‘nubs’. The larger is the hat one. I its a bit of a tight fit in the hat, but that is so that it holds well. There is not a lot of contact between the head and the hat alone to glue. the smaller nub is a crystal for the center of the glob that goes on the staff.The hat is printed off the plate a bit, which makes a bit more waste material, but I found that with the subtle bends in the brim of the hat, it's almost impossible to remove the support material if it's just the interface layer. I also tried to get the little yellow crystal to show by printing in a translucent blue, but alas, no go. If anyon