Jeep passenger-side replacement handle

It's just a tad unrefined, but when the passenger-side inside handle on my vehicle broke, I had a devil of a time finding a replacement part. Well it is a 25-year-old Jeep Grand Cherokee, after all.

Anyway, I wanted it fixed so I whipped this up in OpenScad. Should fit a Jeep Grand Cherokee of circa-1994 model year, maybe other nearby model years as well.

Print with supports at least on the ends where it tilts up off the bed. Also, because it's a handle, better than 50% infill is recommended: I did mine with 80%. If you live in a hot climate, consider printing it in ABS so it doesn't melt in summer temps.