Thingiverse
Jellybean X2 Beta 1
di jbalat
23
Download
16
Likes
0
Makes
Beware this is Beta 1 only - it has not been tested. Please feedback any information if you decide to make one.
This is a new version of the Jellybean X. It is designed so that all electronics can be assembled outside and dropped in from the top. This allows for a quick changeover in case you break your frame. The top just sits in place and can be secured with some clear tape. It adds extra strength and stiffness to the quad. Print in ABS and use Acetone vapour for extra strength. Supports and cleanup a must for the Lid.
Use Cicada BLHeli-S escs no more than 12mm wide. 3 inch racecraft props with 1306 red bottom 4000kv motors. Small vtx, rx and camera. We use the CCD 1000TVL from multirotor shop. Use 4S 500mah or smaller batteries.
This is a new version of the Jellybean X. It is designed so that all electronics can be assembled outside and dropped in from the top. This allows for a quick changeover in case you break your frame. The top just sits in place and can be secured with some clear tape. It adds extra strength and stiffness to the quad. Print in ABS and use Acetone vapour for extra strength. Supports and cleanup a must for the Lid.
Use Cicada BLHeli-S escs no more than 12mm wide. 3 inch racecraft props with 1306 red bottom 4000kv motors. Small vtx, rx and camera. We use the CCD 1000TVL from multirotor shop. Use 4S 500mah or smaller batteries.
Hai stampato questo modello? Accedi e condividi il tuo make!
Accedi per lasciare un commento
AccediAncora nessun commento – sii il primo!
