Jenga(TM) pistol

The term “game changer” is horribly overused these days, but in this case it actually applies. Pull this puppy out the next time you encounter that impossible block and watch your opponents howl in righteous indignation as you knock it across the table and onto the floor. Please laugh maniacally as you do so. PLA should work fine, but use whatever filament you like. Assemble the pieces as shown, snap on the other half (use a mallet if needed) and install as many rubber bands as you deem necessary. To cock, pull the plunger back while pushing the trigger bar into place (see photo). Place the tip of the plunger against the block you wish to remove and pull the trigger. Just try to keep from snickering! A fair amount of effort went into making this work as intended, but please let me know if it gives you any trouble beyond becoming an outcast among your crowd of Jenga(TM) purists.