Thingiverse
jet switch cover for PC start button
by alonx9
2
Downloads
2
Likes
0
Makes
fighter jet styled switch cover but for your PC start button.
printed in two separate pieces and assembled later.
top part (the red cover) should be printed on it's side and with regular support.
and the bottom part (the gray bottom stand) should be printed as the stl, and with NO support because of the bridging of the hinge.
after printing i taped it in place with thin double-sided tape and only after that i connected the top part.
printed in two separate pieces and assembled later.
top part (the red cover) should be printed on it's side and with regular support.
and the bottom part (the gray bottom stand) should be printed as the stl, and with NO support because of the bridging of the hinge.
after printing i taped it in place with thin double-sided tape and only after that i connected the top part.
alonx9 also publishes on
2 additional models across 1 more platforms
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
