Thingiverse
JeVois Camera Tripod Adapter
door NotionalLabs
14
Downloads
16
Likes
1
Makes
This is an initial attempt at creating a basic JeVois camera module mounting plate that will fit common tripods and 1/4" UNC bolt fixings.
I used the mounting pattern from http://jevois.org/doc/CaseMounting.html - the official documentation state that the JeVois case mounting holes are spec'd for M2.5/2-56 screws, but I found that M2 screws had the right diameter to bite the plastic without being over-tight. I'd recommend M2x6 screws to account for the 1mm countersink in the plate - I also used an M2 washer on each screw.
The UNC nut fitting is tight but does require a small dab of superglue to retain it. The OpenSCAD file is included if you need to make tolerance tweaks for your printer.
I used the mounting pattern from http://jevois.org/doc/CaseMounting.html - the official documentation state that the JeVois case mounting holes are spec'd for M2.5/2-56 screws, but I found that M2 screws had the right diameter to bite the plastic without being over-tight. I'd recommend M2x6 screws to account for the 1mm countersink in the plate - I also used an M2 washer on each screw.
The UNC nut fitting is tight but does require a small dab of superglue to retain it. The OpenSCAD file is included if you need to make tolerance tweaks for your printer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
